Before you buyCutting techniqueBuying guideNews#workshop setup#buying guide#composite panel#sheet goods#V-groove#acrylic and polycarbonate
Cutting technique
Cutting Acrylic and Polycarbonate Without Chipping the Edge
Chipped acrylic and crushed twin-wall are support problems more often than blade problems. What to change.
September 18, 2026
Buying guide
Track Saw, Vertical Panel Saw or Cutting Table: What Each One Costs You
An honest comparison of the three ways a small shop cuts sheet goods, including where each one loses.
September 18, 2026
Cutting technique
V-Grooving Composite Panel: How a Flat Sheet Becomes a Folded Return
How a 90 degree groove turns a flat composite sheet into a folded corner with no seam, and the four ways it fails.
September 18, 2026
Cutting technique
How to Cut a Full Sheet Square Without a Panel Saw
A full sheet is only square if it is supported and guided the whole way. What goes wrong on trestles, and the fix.
September 18, 2026
News
Introducing the RailTable 4000
A 157 in single-piece frame, a 20 mm (0.79 in) profile rail over its full span and two carriages that take the tools you
August 17, 2026