Moving a 13-Foot Cutting Table Between Shops
The legs unbolt. The frame does not. What that means for a move, a first delivery, and a shop that might relocate.
September 18, 2026
Dust Extraction for a Cutting Table That Does Not Move
A fixed cutting station is the only kind that gets a permanent extraction run. What to put in, and in what order.
September 18, 2026
A Sign Shop on One Table: Cutting, Grooving and Folding in One Setup
How a two-person sign shop gets a fascia, a set of letters and a returned edge off one bed without moving the panel.
September 18, 2026
Cutting MDF and Melamine Clean on Both Faces
Melamine chips on the face the blade leaves. Support, scoring, blade and feed, in the order that matters.
September 18, 2026
Panel Saw Accuracy: The Four Things Worth Measuring
Squareness, repeatability, straightness and edge quality are four faults with four causes. How to measure each.
September 18, 2026
Fabricating ACM Panels: A Shop Guide From Sheet to Installed Cassette
Cut, groove, fold, rivet, hang. The whole sequence for a composite cassette, and where each step goes wrong.
September 18, 2026
Cutting Twin-Wall Polycarbonate to Length Without Crushing the Flutes
Multiwall is hollow, light and easy to ruin. Why the damage happens at the overhang, and how to avoid it.
September 18, 2026
Repeat Cuts Without Measuring: Why the Stop Matters More Than the Blade
Every measurement in a batch is a chance to be wrong. Why a physical stop beats a good tape.
September 18, 2026
What a 13-Foot Cutting Table Needs From Your Shop Floor
Floor run, walking room, working height, power, and how a 13-foot crate gets through your door.
September 18, 2026